25
AUS
Total time can be different from
the time indicated at the beginning
since it can change while the
program is running, depending
on the temperature of the room
where your machine is installed,
temperature of the supply water,
auto-cleaning of the water softening
system (regeneration) and amount
of the dishes.
Adding Functions to the
Program
With the help of the add function
buttons, you can run the selected
program together with the Half Load
(5) and Delayed Start (6) functions.
To add a function to the program:
1. Select the program by pressing
program selection button (4).
2. Press the button of the function
that you want to enable and check
to see a indicator for the relevant
function on the display.
3. You can start the program by
pressing the Start / Pause /
Cancel button (2).
Program Steps Follow-up
You can follow up the step while
current program is running from the
Program Steps follow up indicator (15)
a Washing Step Indicator (15 a)
b Drying Step Indicator (15 b)
c End of Program Indicator (15 c)
The display shows the steps for
washing 15 a and drying 15 b,
respectively, while the selected
program is running. Only the End of
Program indicator 15 c lights up when
the program is over. Remaining Time
Indicator (3) displays “0:00”.
Canceling a Program
Press Start / Pause / Cancel button (2)
for three seconds to cancel a program
that is already running. Release the
button when symbol (12) start
ashing in the display. For a couple of
minutes the machine will fulll the
necessary operations required for
cancellation. Remaining time indicator
(11) displays “0:00”. You may select
and operate a new program following
the program cancellation process.
There might be residues of detergent
or rinse aid left in the machine and/or
on the pieces being washed depending
on the step the previous program was
in at the time of such cancellation.
Changing a Program
If you want to change running program,
rst of all press Start / Pause / Cancel
button (2) to switch your machine into
pause mode. Second, switch to the
desired program by pressing Program
Selection button (4). Third, Start the
new program by pressing Start / Pause
/ Cancel button (2) again. Your new
selection will resume operation from
the step in the previous program (For
example, if the previous program was
in rinsing step, the new one will also
start from the rinsing step). If you want
to run the newly selected program from
the beginning, you have to apply the
program cancellation process rst and
then select a new program.
Programming the Delayed
Start
You can delay the start of the selected
program until 9 hours. Delayed start
can not be set after the program starts.
The selected program must not be
To Next Page
Loading...
