31
AUS
Cleaning the spray arms
Dirt or calcium residue may block the
nozzles on the spray arms. For this
reason, regularly check the spray
nozzles.
1. Lower spray arm
2. Upper spray arm
1. Remove the lower basket from the
machine.
2. Pull off the lower spray arm in an
upward direction (A).
3. Loosen the fastening screw of the
upper spray arm and pull off the
spray arm (B).
4. Clean the spray arms under
running water.
5. Replace the spray arms.
Ensure that the fastening screws are
screwed tight.
1032
Cleaning the lter inset in the water
inlet hose (depends on the model)
Dirt from deposits in the water pipes is
prevented by a lter in the water inlet
hose. Check the lter and the water
inlet from time to time.
1. Close the water tap and unscrew
the water inlet hose.
2. Take out the lter and clean it
under running water.
3. Replace the cleaned lter.
4. Fasten the water inlet hose to the
water tap again.
To Next Page
Loading...
