7
AUS
Use a screw-on hose connector to
connect the water inlet hose to a water
tap with a ¾ inch external thread. If
required, use a lter insert to lter
deposits from the pipes.
Check that the connection does not
leak.
For safety reasons, turn off the tap
after every rinse process.
Water connection
Not recommended to run with hot
water.
• There are two different types of
water inlet hoses:
- Cold water inlet hose (up to
25°C)
- Hot water inlet hose (up to
60°C)please check which one is
applicable to your model.
If you are willing to connect
your machine to natural
energy resources or to the central
hot water supply, rst check out
whether your water inlet hose
type is suitable by checking the
temperature values written on the
hose. If your hose is not suitable,
apply to your authorized service to
change the hose.
• The dishwasher may not be
connected to open warm water
devices or ow-through water
heaters.
Permitted water pressure:
Lowest permitted water pressure: 0.3
bars = 3 N/cm² = 30 kPa
When the water pressure is below 1
bar, please contact your technician.
Highest permitted water pressure: 10
bar = 100N/cm² = 1Mpa
When the water pressure is above 10
bars, a pressure reduction valve must
be installed (available in trade supply
stores).
Connect water inlet hose
Ensure that the water inlet hose is not
bent or squeezed. Do not install a used
hose set.
1009
AQUASAFE+ (some models)
The AQUASAFE+ System protects
against water damage which may be
caused at the water inlet hose.
Do not immerse the system’s valve
box into water; it contains electrical
components.
In case of damage, pull out the
power supply plug.
Do not shorten or lengthen the
hose insert as it contains electrical
cables and components.
2550
To Next Page
Loading...
Need help?
General
