Operating Instructions BMP-E165
Section 4 - Transport April 2006
©Blastrac April 2006
21
4.1 Transporting the Machine
When transporting the machine make sure that impact damage is avoided. Use
straps to secure the machine on the vehicle. Use at least two straps and secure
the machine firmly. Secure the straps over the housing at the base of the motor
on the rear of the machine and through the handle on the front of the machine.
Never secure the straps over the motor. Make sure that the belts being used
are rated to withstand the weight of the machine.
4.2 Moving the Machine by Hand
Before moving the machine tip the machine back slightly to remove the scarifier
drum from the work surface. See Section 3.1 “Description of Machine”. With
the scarifier drum raised, the machine can be moved easily by hand.
The machine is transported in parts:
• Scarifier
• Dust Collector
• General Accessories
4.3 Transporting with Lifting Gear
To move the machine with lifting gear such as a crane or elevator, note the
maximum permitted weights. Use only approved and tested slings.
For the machine weight see Section 2.1 “Machine Specifications” or check the
ratings plate.
4.4 Procedure for Moving the Machine During Scarifying
Refer to Section 5.2 “Starting” for all procedure related to starting the machine
and moving the machine during scarifying.
To Next Page
Loading...
