Operating Instructions BMP-E165
Section 6 – Operation February 2006
©Blastrac February 2006
30
6.4 What To Do When Faults Occur – Emergency Stop
In the event that any fault occurs, to the scarifier or the dust collector, an
emergency stop should be executed by depressing the e-stop button (See Figure
3.3) and both machines should be placed in “Maintenance Mode”. See Section
1.7 “Maintenance Mode”.
All safety issues, instruction and cautions contained within this
manual should be complied with at all times. See Section 1
“Safety Precautions”.
In addition to these Manual instructions and cautions, all
statutory and other binding (law) accident prevention
regulations such as OSHA, state and/or local entity articles
should be a part of operator training. This type of obligation
may govern, i.e. handling of hazardous materials or wearing
personal safety equipment. Some of these are listed in the
Section 1.2 “Statutory Safety Considerations”.
Once an emergency stop has been executed and the machine is in the
“Maintenance Mode”, personnel may begin troubleshooting to determine the
cause of the fault. Both machines should stay in the “Maintenance Mode” until
the cause of the fault has been determined and corrected.
6.5 Restarting After Breakdowns
All safety issues, instructions and cautions contained within
this manual should be complied with at all times. See Section 1
“Safety Precautions”.
For restarting the machine after a breakdown or after any maintenance work, see
Section 5 “Preparation/Starting”
To Next Page
Loading...
