Blastrac BMP-E165 - Page 49

Operating Instructions BMP-E165
Section 10 – Spare Parts April 2006
©Blastrac April 2006
48
Use only sufficient scarifier cutters and spacers so that the
tools can still move freely (axial plan min. 1-3mm). To avoid an
unbalanced scarifier drum each shaft must have the same
number of cutters and spacers.
ITEM QUANTITY CATALOG
NUMBER
DESCRIPTION
1 82 AT-999-6851 CUTTER / TSR3.5
2 293 AT-999-664 WASHER/1.5mm
444444441
54444444
333333332
333333332
233333333
54444445
4444444
54444445
233333333
533333331
5
4
3
2
1
2
1