12
5. USAGE OF THE ROBOT & AUTO STATION
REMOVE THE LIMIT BAR
Put the robot on the flat indoor ground, and remove the protection device
of the limit bar at both ends of the front bumper.
CHARGING OF THE ROBOT
Press and hold the button for 3 seconds to start the robot, and then
short-press the button to make the robot recharge automatically. The
robot is ready once fully charged.
• Fully charge the robot before starting cleaning.
• Before starting the cleaning, tidy away the wires and articles on the
ground to avoid damage caused by winding, dragging and hitting during
cleaning.
• It is suggested to start the robot at the auto station.
• When the battery is low during the cleaning, the robot will automatically
return to the auto station for charging, and automatically return to the
interrupted place to continue cleaning when the battery is full.
0.5m
0.5m
1.5m
To Next Page
Loading...
