Blaupunkt BREMEN MP76 - Crossover; TMC for Dynamic Navigation Systems

48
Crossover
In crossover mode, the high frequencies are
played via the front channels and the low
frequencies via the rear channels.
Press the AUDIO button :.
"AUDIO MENU" appears on the display.
Press the NEXT button 4.
"AUDIO MENU 2" appears at the bottom of
the display.
Press the softkey 5 with the display
label "CROSSOVR".
Crossover is now adjusted.
To be able to use the crossover mode, you
must set the high-pass fi lter and the low-
pass fi lter.
Press the softkey 5 with the display
label "HIPASS" for setting the high-pass
fi lter.
Press the joystick 8 left or right to
adjust the frequency for the high-pass
fi lter.
Press the softkey 5 with the display
label "LOWPASS" for setting the low-
pass fi lter.
Press the joystick 8 left or right to
adjust the frequency for the high-pass
fi lter.
The settings are automatically saved.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
TMC for dynamic navigation
systems
TMC stands for "Traffi c Message Chan-
nel". Traffi c reports are broadcast digitally
via TMC, which means they can be used
by compatible navigation systems during
route planning. Your car sound system has a
TMC output, which you can use for connect-
ing Blaupunkt navigation systems. You can
fi nd out from your Blaupunkt dealer which
navigation systems can be used with your
car sound system.
Subwoofer and centre speaker TMC
01BremenMP76US_gb.indd 4801BremenMP76US_gb.indd 48 7/28/06 11:28:29 AM7/28/06 11:28:29 AM