51
ENGLISH
Miscellaneous
Entering a switch-on message
If you switch on the device, a brief message
is shown on the display as scrolling text.
This text is factory set to "BLAUPUNKT-THE
ADVANTAGE IN YOUR CAR". Instead, you
can enter your own text of up to 35 char-
acters.
Press the MENU button 9.
Press the softkey 5 with the display
label "VARIOUS".
Press the softkey 5 with the display
label "ON MSG".
The display shows the standard text for the
switch-on message. The input mark is at the
beginning of the line and fl ashing.
To input a different text,
press the joystick 8 left or right to
move the input mark.
Set the desired letter by pushing the
joystick 8 up or down.
After entering the message, press the
OK joystick 8 or the MENU button 9
to exit the menu.
The settings are saved.
쏅
쏅
쏅
쏅
쏅
쏅
Displaying the serial number
You can display the serial number of the
device.
Press the MENU button 9.
Press the softkey 5 with the display
label "VARIOUS".
Press the softkey 5 with the display
label "SER NUM".
The serial number of the device is displayed
in the top line of the display.
Press the OK joystick 8 or the MENU
button 9 to exit the menu.
Resetting the device
You can reset the device to the factory-pre-
set parameters. All personal settings are
lost in the process.
Press the MENU button 9.
Press the softkey 5 with the display
label "VARIOUS".
Press and hold the softkey 5 with the
display label "NORMSET" for longer
than two seconds.
The device switches off and automatically
on again.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Miscellaneous
01BremenMP76US_gb.indd 5101BremenMP76US_gb.indd 51 7/28/06 11:28:30 AM7/28/06 11:28:30 AM
To Next Page
Loading...
