Blaupunkt Buenos Aires 200 - Sound Settings; Audio Menu Navigation; Audio Adjustment Parameters; Audio Source Level Adjustment

11
ENGLISH
Sound settings
Sound settings
The settings in the audio menu and the adjust-
ment of the level each apply to the current audio
source.
Calling and exiting the audio menu
If necessary, press the On/Off button 4
repeatedly until the desired audio source is
selected.
Briefl y press the AUD button 9 to open the
audio menu.
Press the AUD button 9 repeatedly until the
desired menu item is selected.
Perform the setting (see the next section).
Briefl y press the MENU button ? to exit the
audio menu.
Performing settings in the audio
menu
SW L
Subwoofer level. Settings: -15 to +15.
Turn the On/Off button
4 to perform the
setting.
X-BASS
Increase of bass at low volume. Settings: OFF, 1,
2 (highest increase).
Turn the On/Off button
4 to change be-
tween the settings.
NATURAL / ROCK / POPS / EASY / TOP40 /
JAZZ / GAME / USER
Equaliser presettings: NATURAL, ROCK, POPS,
EASY, TOP40, JAZZ, GAME.
"USER" is not an equaliser presetting and appears
as a menu item only if you manually adjusted the
bass, treble or middle level the last time. As soon
as you select an equaliser presetting, your manu-
ally performed settings are replaced by the pre-
setting.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Turn the On/Off button
4 to change be-
tween the settings.
BAS L
Bass level. Settings: -7 to +7.
Turn the On/Off button
4 to perform the
setting.
MID L
Middle level. Settings: -7 to +7.
Turn the On/Off button
4 to perform the
setting.
TRE L
Treble. Settings: -7 to +7.
Turn the On/Off button
4 to perform the
setting.
BAL
Left/right volume distribution (balance). Set-
tings: L 9 (left) to R 9 (right).
Turn the On/Off button
4 to perform the
setting.
FAD
Front/rear volume distribution (fader). Settings:
F 9 (front) to R 9 (rear).
Turn the On/Off button
4 to perform the
setting.
Adjusting the level for an audio
source
You can separately adjust the level for any audio
source, e.g. to achieve a uniform playback level
for all audio sources. Settings: For AUX -8 to +8,
for all other audio sources -8 to 0.
If necessary, press the On/Off button
4
repeatedly until the desired audio source is
selected.
Press the AUD button 9 for approx. 2 sec-
onds.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
01_BuenosAires200_us_gb.indd 1101_BuenosAires200_us_gb.indd 11 14.11.2008 13:24:41 Uhr14.11.2008 13:24:41 Uhr