46
Making settings in the "VARIOUS"
menu
SCAN TIME
Setting the scan time in 5-second increments.
Settings: 5 – 30.
쏅 Press the
button
7
to open the submenu.
쏅 Turn the volume control
4
to perform the
setting.
BROWSE
Switching fast track selection in browse mode on
or o using the volume control
4
. Settings: ON,
OFF.
쏅 Press the
button
7
to open the submenu.
쏅 Turn the volume control
4
to perform the
setting.
SEC CODE
Switching the code query on or o . Settings: ON,
OFF.
쏅 Press the
button
7
to open the submenu.
쏅 Turn the volume control
4
to perform the
setting.
CODE SET
The default setting of the code number is "0000".
This code number can be changed.
쏅 Press the
button
7
to open the entry
menu.
The display shows the currently stored code
number:
쏅 Turn the volume control
4
to select a digit
for the respective position.
쏅 Press the
or button
7
to reach the next
or previous position.
Note:
While entering the code number, you cannot
change the volume of the car sound system.
NORMSET
Restoring the original factory settings of the car
sound system.
쏅 Press the
button
7
to open the submenu.
쏅 Press the
button
7
to con rm restoring
the factory settings.
The car sound system switches o and is reset
to the factory settings.
Factory settings
Important factory settings in the user menu:
Menu item Factory setting
AREA EUROPE
FM1 / FM2 / FMT ON
MW* ON
AM** / AMT** ON
RDS ON
REGIONAL* OFF
TRAFFIC* OFF
SEEK SENS HI6
PTY OFF
ON VOLUME 20
LAST VOL OFF
TA VOLUME* 20
BEEP ON
BROWSE ON
SCAN 10
SCROLL X1
SEC CODE OFF
MIC TYPE FRONT
* Only in reception area "EUROPE"
** Only in reception areas "USA", "S-AMERICA" and
"THAILAND"
In the user menu, you can restore the original
factory settings of the car sound system (see the
chapter "User settings", section "Making settings
in the "VARIOUS" menu", menu item "NORMSET").
User settings | Factory settings
To Next Page
Loading...
