EasyManua.ls Logo

Blaupunkt Cupertino 220 - Playback Control and Navigation

Blaupunkt Cupertino 220
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Inserting/ejecting a CD
Inserting a CD
Risk of severe damage to the CD
drive!
Noncircular contoured CDs (shape CDs)
and CDs with a diameter of 8 cm (mini CDs) must
not be used.
We accept no responsibility for any damage to the
CD drive that may occur as a result of the use of
unsuitable CDs.
Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
Insert the CD with its printed side up into the
CD tray
5
until you feel a slight resistance.
The drive automatically draws in the CD and
checks its data. Afterwards, the playback
starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD
ERROR" is brie y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.
Ejecting a CD
Note:
You must not hinder or assist the drive as it
ejects the CD.
Press the
button
8
to eject an inserted
CD.
Notes:
If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
You can also eject CDs while the car sound
system is switched o or whilst another au-
dio source is activated.
Connecting/removing a USB data
carrier
Connecting a USB data carrier
Switch o the car sound system so that the
data carrier will be correctly registered.
Pull the protective cap of the USB socket
9
to the front until it moves out of the socket
and fold it to the right.
Connect the USB data carrier.
Turn on the car sound system.
If the USB data carrier is initially selected as
audio source, the data are read  rst.
Notes:
If the connected USB data carrier cannot
be seen, "USB ERROR" is brie y displayed.
The time required for reading in the data
depends on the design and size of the USB
data carrier.
Removing a USB data carrier
Switch o the car sound system so that the
data carrier will be correctly unregistered.
Disconnect the USB data carrier.
Close the protective cap of the USB socket
9
.
Selecting tracks
Press the / button
7
brie y to change
to the previous/next track.
Note:
If the current track plays longer than 3 sec-
onds, pressing
7
once restarts the track.
Selecting a folder
(only in MP3/WMA/iPod mode)
Press the / button
7
brie y to change
to the previous/next folder.
Note:
In iPod mode, this allows you to change to the
previous/next folder of the current category,
e. g. to the next genre, if you previously se-
lected a track on the iPod via the correspond-
ing genre.
CD/MP3/WMA/iPod mode

Table of Contents

Related product manuals