14
Switching to radio mode
If you are in CD, CD changer or AUX mode,
press the BAND/TS button =
or
press the SOURCE button 3 repeat-
edly until the memory bank, e.g. "FM1",
appears on the display.
Selecting the waveband/memory
bank
This device can receive programmes broad-
cast over the FM and AM frequency bands.
There are three memory banks available for
the FM waveband (FM1, FM2 and FMT) and
one for each of the AM waveband.
Five stations can be stored in each memory
bank.
To switch between the FM memory banks
(FM1, FM2 and FMT) and the AM wave-
band,
briefl y press the BAND/TS button =.
Tuning into a station
There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
Press the
or button :.
The radio tunes into the next receivable sta-
tion.
쏅
쏅
쏅
쏅
Tuning into stations manually
You can also tune into stations manually.
To change the set frequency in small incre-
ments,
briefl y press the
or button 8.
To change the set frequency quickly,
press and hold down the
or button
8 for a longer period of time.
Setting the sensitivity of station
seek tuning
You can choose whether the radio should
only tune into stations providing good re-
ception or whether it can also tune into
those with a weak reception.
Press the MENU button ;.
Press the
or button : repeatedly
until "SENS HI" or "SENS LO" appears
on the display.
The display shows the current setting for
the sensitivity level. "SENS HI" means high,
"SENS LO" low sensitivity.
Set the desired sensitivity with the
or
button 8.
When you have fi nished making your
changes,
press the MENU button ;.
Note:
The device stores the sensitivity value
set in the respective FM and AM wave-
band.
쏅
쏅
쏅
쏅
쏅
쏅
Radio mode
To Next Page
Loading...
