16
If the CD is not automatically drawn in,
briefl y press the button ?.
You must not hinder or assist the drive as it
draws in the CD.
Gently close the control panel whilst
exerting a little pressure until you feel
it click into place.
The CD playback starts and "CD" is shown
on the display.
Note:
If the vehicle ignition was switched
off prior to inserting the CD, you must
switch the device on fi rst with the On/
Off button 6 to start the playback.
If a CD is already inserted in the drive,
press the SRC button 2 repeatedly
until "CD" appears on the display.
Playback begins from the point at which it
was last interrupted.
Selecting tracks
Press one of the arrow keys or 4
or
or 4 to select the next or pre-
vious track.
If you press the
button 4 once, the
current track will be played again from the
beginning.
Fast searching (audible)
To fast search backwards or forwards,
press and hold down the
or button
4 until fast searching backwards/for-
wards begins.
쏅
쏅
쏅
쏅
쏅
Random track play (MIX)
Press the 5 MIX button 9.
"MIX CD" appears briefl y on the display and
the MIX symbol is displayed. The next ran-
domly selected track will then be played.
Cancelling MIX
Press the 5 MIX button 9 again.
"MIX OFF" appears briefl y on the display
and the MIX symbol disappears.
Scanning tracks (SCAN)
You can scan (briefl y play) all the tracks on
the CD.
Press and hold down the MENU•OK
button 5 for longer than two sec-
onds.
The next track will then be scanned. "TRK
SCAN" appears on the display and the
current track number is fl ashing.
Note:
You can set the scan time. For further
information, please read the section
entitled "Setting the scanning time" in
the "Radio mode" chapter.
Cancelling Scan and continuing listening
to a track
To end the scanning process,
press the MENU•OK button 5.
The currently scanned track will then con-
tinue to be played normally.
쏅
쏅
쏅
쏅
CD mode
01_LondonMP48us_gb.indd 1601_LondonMP48us_gb.indd 16 11/20/07 9:56:32 AM11/20/07 9:56:32 AM
To Next Page
Loading...
