46
Switching REGIONAL on/off
Press the MENU•OK button 5.
Press the
or button 4 repeatedly
until "REG" appears on the display.
"OFF" or "ON" is displayed alongside
"REG".
To switch REGIONAL on/off,
press the
or button 4.
When you have fi nished making your chang-
es,
press the ESCAPE button <.
Switching the RDS function on/off
To switch the RDS functions AF and
REGIONAL on or off,
press and hold down the TRAF button
3 for longer than two seconds.
If the RDS comfort function is active, the
RDS symbol appears on the display.
Selecting the waveband/memory
bank
This device can receive programmes broad-
cast over the FM frequency range as well as
the MW and LW (AM) wavebands. There are
three memory banks available for the FM
waveband (FM1, FM2 and FMT) and one
for each of the MW and LW wavebands.
Five stations can be stored in each memory
bank.
쏅
쏅
쏅
쏅
쏅
To switch between the FM memory banks
(FM1, FM2 and FMT) and the MW and LW
wavebands,
press the BND button =.
Tuning into a station
There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
Press the
or button 4.
The radio tunes into the next receivable sta-
tion.
Note:
If the priority for traffi c information is
active (the display shows the traffi c
jam symbol), the next traffi c informa-
tion station is set.
Tuning into stations manually
Note:
Tuning into stations manually is pos-
sible only if the convenient RDS func-
tion and the programme type (PTY) is
switched off.
To change the set frequency in small incre-
ments,
briefl y press the
or button 4.
To change the set frequency quickly,
press and hold down the
or button
4 for a longer period of time.
쏅
쏅
쏅
쏅
Radio mode
02_LondonMP48eu_gb.indd 4602_LondonMP48eu_gb.indd 46 15.11.2007 15:20:24 Uhr15.11.2007 15:20:24 Uhr
To Next Page
Loading...
Need help?
General
