Blaupunkt London MP48 - Audio Balance and Fader Settings; Audio Balance and Fader Adjustment; Preamplifier Output Configuration

62
Setting the left/right volume
distribution (balance)
To adjust the left/right volume distribution
(balance),
press the AUD button >.
"BASS" appears on the display.
Press the
or button 4 repeatedly
until "BAL" appears on the display with
the current setting.
Press the
or button 4 to ad-
just the left/right volume distribution
(RIGHT/LEFT).
Press the AUD button > to exit the
menu.
Adjusting the front/rear volume
distribution (fader)
To adjust the front/rear volume distribution
(fader),
press the AUD button >.
"BASS" appears on the display.
Press the
or button 4 repeated-
ly until "FADER" appears on the display
with the current setting.
Press the
or button 4 to adjust
the front/rear volume distribution
(REAR/FRONT).
Press the AUD button > to exit the
menu.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Preamplifi er output
(Preamp-Out/Sub-Out)
You can use the preamplifi er outputs
(Preamp-Out) of the car sound system to
connect external amplifi ers. In addition,
you can connect an amplifi er for operating
a subwoofer to the integrated dynamic low-
pass fi lter of the device (level and cut-off
frequency can be adjusted).
For this purpose, the amplifi ers must be
connected as described in the installation
instructions.
Adjusting Sub-Out
The subout level can be adjusted in 8 in-
crements (0 to +7), and 4 cut-off frequen-
cies can be selected: 0 Hz (linear), 80 Hz,
120 Hz and 160 Hz.
Press the AUD button >.
"BASS" appears on the display.
Press the
or button 4 repeatedly
until "Sub-Out" appears on the display.
Press the
button 4 once to reach
the Sub-Out submenu.
Press the
or button 4 repeatedly
until the desired frequency appears on
the display.
Press the
or button 4 to adjust
the level between 0 and +7.
When you have fi nished making your chang-
es,
press the AUD button > twice.
쏅
쏅
쏅
쏅
쏅
쏅
Sound Preamplifi er output
02_LondonMP48eu_gb.indd 6202_LondonMP48eu_gb.indd 62 15.11.2007 15:20:26 Uhr15.11.2007 15:20:26 Uhr