21
Lübeck CC22
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Tape Section
Inserting a Tape
If you want to listen to a tape:
• Switch on the set.
• Insert the cassette into the slot with the
tape side showing to the right and the
empty reel to the front.
Fast Forwarding the Tape
Fast Forward Operation
• Briefly press the FF button 6.
Stopping Fast Forward Operation
• Briefly press the FF button 6.
Removing the Tape
To stop tape play:
• Press the
button 6 firmly.
The cassette is ejected.
Care Notes
We recommend C-60 and C-90 type tapes
for use in any automobile tape player; to
protect your tapes, store them in a cool place
away from dirt, dust, or excessive tempera-
tures above 50° Celsius. In order to ensure
smooth tape operation, cold tapes should be
allowed to heat up a bit before they are
played. If dust collects on the audio head or
the rubber roller, problems related to rough
tape operation or poor sound quality may
occur after approx. 100 hours of operation.
For normal contamination, use a head-
cleaning cassette to remove the dust; for
more intensive contamination, use a cotton-
wool tip soaked with alcohol. Never use hard
tools!
Appendix
Technical Data
Amplifier
Output power: 2 x 10 W watts RMS
acc. to DIN 45324/3.1
2 Ω
FM
Sensitivity: 0.9 µV at 26 dB
signal-to-noise ratio
Frequency
response: 35 - 16 000 Hz (-3 dB)
Tape Section
Frequency
response: 30 - 14 000 Hz (-3 dB)
Modifications reserved!
To Next Page
Loading...
