17
Lübeck CC22
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
Restart following interruption of
power supply
(Code system switched on)
• Switch on the set.
“COD” will appear in the display.
• Briefly press preset button 1, “000” will
appear in the display.
• Enter the code number given in the
Blaupunkt car radio passport:
Preset button 1 only allows to choose
“0” or “1”. The first “0” will not be dis-
played.
Example: the code number is 0521.
- Press preset button 1 until “000” ap-
pears in the display.
- Press preset button 2 five times,
“500” appears in the display.
- Press preset button 3 twice, “520”
appears in the display.
- Press preset button 4 once, “521”
appears in the display.
• To confirm the code number:
Press the
upper part of the rocker
switch
.
Your car radio is now ready for operation.
If three dashes appear again in the display,
you have entered a wrong code number.
Amplifier Section
ON/OFF
For switching the set on,
• turn button 1
.
Your stereo is now ready for operation.
For switching the set off,
• turn button 1
.
Balance Control
Use button C to balance the sound impres-
sion of the right and left channel speaker.
Sound Control
Use the TONE button D to adjust the sound
according to your personal preference.
Now it is essential to enter the correct code
after the waiting period has elapsed (COD in
the display).
If the radio is turned off before the waiting
period has elapsed, then the waiting period
restarts as soon as the radio is turned on
again.
Switching the code system off
• Turn off the radio.
• Simultaneously press preset buttons 1
and 4 and hold them down.
• Turn the set on.
“COD” will appear in the display.
• Enter the code number given in the
Blaupunkt car radio passport and con-
firm: See example “Restart following
interruption …”.
The code system is now deactivated.
To Next Page
Loading...
