Blaupunkt Munchen RD 104 User Manual

MÜNCHEN RD 104 Inland
22
If “SEARCH” appears in the display when
turning on the set or when calling up one of
the stored frequencies, the set is automati-
cally searching for an alternative frequency.
“SEARCH” goes out as soon as the system
has found an alternative frequency or after
the frequency band has been scanned com-
pletely.
Should the reception quality of the selected
program become too bad,
• tune into another program.
REG - Regional
The AF function can also be used to acivate
and deactivate the regional function.
At some times of the day, larger radio stati-
ons split up their main program into regional
program versions offering local information.
If you want the radio to lock onto a regional
program,
• hold down the AF button for about 2
seconds.
The display will show “REG ON”.
If you leave the service area of the regional
station tuned in, or if you wish to use the
entire RDS service again, switch to “REG
OFF”.
• Hold down the AF button for about 2
seconds until “REG OFF” is displayed.
If “REG ON” is activated, the display will
show “REG ON” each time the radio is swit-
ched on.
Selecting a station
This set allows you to receive FM stations
between 87.5 and 108 MHz.
Automatic seek tuning
/
• Press / . The radio will automatically
tune into the following station.
If you keep the upper or lower part of the
rocker switch
/ depressed, seek tuning
speeds up in upwards or downwards directi-
on.
up
Manual seek tuning
(prerequisite: AF is switched off!)
• Press << or >> to change the frequency
in small steps in upwards/downwards
direction.
Hold down the right or left part of the rocker
switch to speed up this procedure.
Adjusting the seek tuning sensi-
tivity
The set allows you to modify the seek tuning
sensitivity.
If “lo” is indicated, the radio will only pick up
strong stations (low sensitivity).
If “lo” is deactivated, the radio will also pick
up less powerful stations (higher sensitivity).
The degree of sensitivity can be separately
adjusted for both levels (see chapter “DSC
programming”).
Stereo - mono switch (FM)
You can switch to mono when the reception
quality becomes poor:
• Press lo for approximately 2 seconds.
During mono reception the stereo symbol
in the display will go out.
Each time the car radio is switched on, the
radio will be automatically set to stereo recep-
tion.
down
down in short
intervals
up in short
intervals

Blaupunkt Munchen RD 104 Specifications

General

Brand	Blaupunkt
Model	Munchen RD 104
Category	Car Receiver
Language	English