Blaupunkt Munchen RD 104 User Manual

23
MÜNCHEN RD 104 Inland
DEUTSCH
ENGLISH
ITALIANO
PORTUGUES
NEDERLAND
ESPAGÑOL
SVENSKA
FRANÇAIS
It will automatically switch to mono when the
reception quality becomes poor.
Changing the memory bank (FM)
You can shift between the memory banks I
and II to store and recall preset stations.
The selected memory bank is indicated in the
display.
• Press FM until the desired memory
bank lights up in the display
(press repeatedly if necessary).
Storing stations
Using the preset buttons 1, 2, 3, 4, 5, 6 you
can store six stations on each FM memory
bank (I, II, T).
• Press the FM or TS button to select the
waveband.
• Use the rocker switch to tune to a stati-
on (either automatically
/ or manual-
ly
).
• Press the desired preset button and
hold it down. The radio will be muted
and resumes play after approximately 2
seconds.
Now the station is stored. The activated pre-
set button is indicated in the display.
Note:
If you tune into a station which has already
been stored, the corresponding preset button
and the memory bank will start flashing in the
display for a short while.
Storing the strongest stations
automatically with Travelstore
You can use the Travelstore memory bank to
automatically store the six strongest FM sta-
tions sorted on the preset buttons according
to their signal strength. This feature is espe-
cially useful when travelling, because it will
always give you the most powerful stations at
a fingertip as you pass through the various
reception areas.
• Press TS for at least 2 seconds.
The radio will seek the most powerful FM
stations and store them on the “T” memory
bank (Travelstore). As soon as this procedu-
re has finished, the first station will be played.
FM stations can also be stored manually on
the Travelstore memory bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station by pressing
the corresponding preset button.
• Select FM or TS and with FM also the
desired memory bank.
For this purpose, press FM until the
desired memory bank is indicated on
the display.
• Briefly press the corresponding preset
button.
Sampling stored stations briefly
with Preset Scan
With this function you can briefly sample all
preset stations.
• Press PS.
The radio will briefly play all the stored
stations of the tuned in waveband one
after another.
On FM, the system will sample the stations of
one of the memory banks I, II, or T, depen-
ding on which bank was selected before.
Free preset buttons will be skipped.
To switch off Preset Scan:
• Press PS once again.
The radio will continue to play the cur-
rently sampled station.

Blaupunkt Munchen RD 104 Specifications

General

Brand	Blaupunkt
Model	Munchen RD 104
Category	Car Receiver
Language	English