Blinc BL A2 - BL A2 Device Operation and Pairing; Power On and Off; Bluetooth Phone Pairing; Multipoint Bluetooth Pairing

4
Power On
Push and hold the “Power” buon for at least 2 seconds to
power on. The Blue LED turns on and you will hear ascending
beeps an “Power on”
Power o
Push the “Power” and “Phone” buons at the same me for 2
seconds, the red Led turns on for about 1 second unli t turns
o completely and you will hear “Power o”.
Pairing with Phone
Please make sure the Blinc-A2 is in power o posion. Push the
“Power” buon for at least 5 seconds ll the LED ashes in red
and blue alternately and you will hear a voice prompt saying
“Pairing” in the speakers. Enable your Bluetooth funcon on
your mobile phone. Your mobile phone will now scan nearby
devices and nd a device named “BLUETOOTH HELMET”. Please
allow your mobile phone to pair with the device. When pairing
has completed and the Blinc-A2 is ready for use you will hear a
voice prompt saying “Pairing succesfull” in the speakers.
Once pairing between the two devices is succesfull, the LED
lights on the Blinc-A2 will change from red and blue ashing
lights to a blue LED light only.
Note: if a PIN codes is required by your mobile phone, please
enter “0000”.
If you paired with your phone and Blinc-A2, Blinc-A2 will
connect your phone automacally when you turn it on again.
Pairing with a second Bluetooth device or mobile phone
Mulpoint Bluetooth pairing allows the Blinc-A2 to connect
two Bluetooth devices at the same me.
You can pair the rst and second Bluetooth device or mobile
phone to the Blinc-A2 by following the simple procedures in
“Pairing with your mobile phone”.
Aer second Bluetooth device or mobile phone conrms that
EN