Blinc BL A2 - Device Management and Maintenance; Pairing with BL300 Device; BL300 Remote Control; Battery Status and Warnings

7
working in 5 seconds if the sound is low, and when you’ll speak
again, the microphone also will working again.
Pair with BL300
Press “Phone” buon about 7 seconds unl blue LED stop
lighng in stand-by mode. Then operate ET300 complete
pairing.
Remote control with BL300
Press the grey buon (Music buon) to play music in your
mobile phone if there no music palying. Push the grey music
buon again to pause the music.
Double click the green buon when Blinc-A2 in stand-by mode
that will start the voice call. When there is an incoming call, you
can press green buon to answer the call.
Double click the green buon to reject an incoming call.
Press the green buon to terminate the call when calling.
Press the green buon to establish the intercom when Blinc-A2
is in stand-by mode, and press again to terminate the intercom.
If you paired the Blinc-A2 with ET200, when you press the RED
buon, the walkie talkie will be into sending state. Aer you
release it, the walkie talkie will be into receiving state.
Press Volume+ buon to track forward song; long press this
buon to increase the volume Press Volume- buon to track
back song; long press this buon to decrease the volume.
Voice prompt indicator for baery capacity
When you power o the headset, simply press the “Power”
buon for 1 second, then you will hear a voice prompt
indicang the baery level:
“Baery full”: 70/100 %
“Baery y percent”: 30/70%
“Baery low”: 0/30%
Low baery warning
When the baery is low, the red LED will blink for every 30
EN