7
1. Install the light on the attachment at the front of
the fender using the bolt and 4mm allen wrench.
Use the 8mm crescent wrench to keep tension.
2. Connect the light cables to the included front
light. The red cable connects to the positive [+]
terminal, and the black cable connects to the
negative [-] terminal.
Step 4: Lights
Assembly
Step 5: Front Wheel & Quick Release
1. Remove both wheel protectors from the axle of
the front wheel.
2. Remove the cap and one of the two springs from
the quick release skewer.
To Next Page
Loading...
