9
Step 6: Pedals
8. With the quick release lever open, tighten the cap,
then clamp down the quick release arm to firmly
attach the wheel to the dropouts. You should feel
firm resistance when closing the lever.
1. The pedals are marked with an “L” for le and an
“R” for right on the end of the axle. The right pedal
should be installed on the side with the chain and
gears.
2. Start by hand-threading each pedal onto the bike.
Then, tighten the pedals securely using the 15mm
crescent wrench.
Note: The le pedal is reverse-threaded and
tightens in the opposite direction. Ensure pedals
thread correctly before tightening to prevent
damage.
Assembly
To Next Page
Loading...
