Self-Contained Ice Maker User Manual for Installation and Maintenance
Maintenance
Note: Maintenance must be done by a
qualified professional personal.
Warning: Before maintenance or
manual clean, be sure to cut off the water
source and power supply.
Exterior cleaning
Frequently clean the environment around
the ice machine to keep it clean. Do not
block the vents.
The outer enclosure should be cleaned with
a mild detergent and then wiped clean. If
necessary, use commercial stainless-steel
cleaners and polishes.
Note: Stainless steel may rust without
proper maintenance. Dry up any spillages.
Do not use harsh sanitizing sprays or
cleansers.
Inlet water filter
The filter element should be inspected
regularly. It is recommended to replace filter
element every 3 to 6 months.
Interior cleaning
The inside of the ice storage bin should be
cleaned regularly with mild detergent /
sanitizer.
Note: Check and confirm the water
pressure lower than the maximum allowed
pressure. Do not flush the part above the
water pump or the evaporator directly for
water protection.
Condenser
For the air-cooled ice maker, the condenser
should be checked / cleaned every three
weeks. Use a soft brush or a vacuum cleaner
with a brush to brush it up and down along the
fin direction, to avoid damage to the fins and
further affecting the cooling effect.
The condenser filter should be cleaned
every 2 weeks.
Note: Be careful when doing the
condenser cleaning as the edges of the
fins are sharp.
Water pipe
In order to ensure food safety, the water pipe
of the ice machine should be cleaned
regularly.
Wintering
Turn off the water and power supply, drain
the residual water from the water trough,
inlet pipe and drainpipe.
The maintenance of the ice machine is
not covered by the manufacturer's
warranty!
Clean Function
Note: Please empty the bin of ice in
advance.
Note: Please clean and sterilizing the
bin and do complete rinsing.
Note: Please clean and sterilizing the
ice sliding board, water distribution pipe,
reservoir, water supply pipe, then do
complete rinsing.
Turn on the ice maker; push “clean”
button for 3 seconds, the ice maker will
get into clean process. Wait until the
water in process finished the led display
flash “Clean” slowly; then drain the water
To Next Page
Loading...