TO ENSURE OPTIMAL PERFORMANCE FROM YOUR ICEMAKER, THE
FOLLOWING IS RECOMMENDED –
• Ensure that the minimum water temperature is not lower than
+5°C or higher than +40°C
• Minimum water pressure is not below 0.1MPa and maximum does
not exceed 0.5MPa
• The electrical supply available corresponds to the voltage and
ampacity of the machine specifications as indicated on the rating
plate
• The electrical cut off switch with fuse protection must be a 2 pole
type with minimum clearance of 3mm between open contacts
• The minimum ambient temperature should not be lower than
+10°C or the maximum higher than +40°C
• Ensure there is a minimum space around the cabinet vents of
150mm to allow air circulation.
• Ensure there are no heat sources (kitchen stoves, cookers, radiators
etc) near the machine and the environment isn’t too humid.
INSTALLATION
• Check the machine is level, and connect the plug to the electrical
cord in compliance with local regulations
• Replace any old/used water hoses with new ones and connect to the
water supply
• Ensure the drain is connected and set up properly using a spiralled
hose. It should have a minimum fall of 3cm per metre
• Open water shut off valve
• Insert plug into mains socket and set the main switch to the ON
position.
To Next Page
Loading...
