16
Power supply
› Plug the power cable into a correctly installed power outlet of your public power system .
Antenna
› Connect the tuner antenna connector to the „Tuner Antenna connection on the back of the device ” .
Signal output
› Connect these jacks to the respective jacks found on your amplifer. Ensure that connections
have been made properly this normally means red to red and white to white ( ).
Network
› A RJ45 cable is used to connect the LAN connection on the device to your router.
W-LAN
› For wireless operation, attach the antenna to the „Wi Fi Antenna connection Your pass - “ . -
word may be required for the wireless network .
Chapter 4 Connection
Connection
To Next Page
Loading...
