43
Chapter 5 Basic operation
5
Basic operation
Setup
› You will be asked if “Setup Wizard” is to be started, when the device is turned on for the frst
time. If you don’t want this to be installed or it is to be started at a later point in time, you will be
able to start this setup function again as follows:
MENU › System settings › Setup Wizard
The following will occur, if the „Setup Wizard” is carried out:
› You can select the desired time format (12/24 hour display).
› Whether and which source is to carry out automatic updates.
› Your time zone (Germany has the time zone +01:00)
› Set the daylight savings options ON/OFF
› Set the W-LAN region (Germany is „Most of Europe“)
FM operation
› Press the „MODE“ button repeatedly or select „Radio Operation“ in the main menu for FM radio
operation.
Stations
Setting stations
› Press the „TUNE +/–“, „ENTER“, the „CONTROL” dial or press the „ “ and „ “ buttons down lon-
ger to start an automatic station search. The search function will stop, once a station has been
found. You can improve the frequency gradually in 0.05 MHz steps by pressing the „ “ and „ “
buttons down shortly or by turning the „CONTROL” dial.
› You can access and use additional settings in the radio menu. Press the „MENU” button.
Select the radio menu option in the main menu, if you have not already gained access to this
menu option.
Scan setting › Select this option to search and stop after a station with good reception has been
found.
Audio setting › Select this setting to play stations with weak signals in mono.
▲
▲
▲
▲
To Next Page
Loading...
