Installation
5
Oven Assembly
PACKAGING
Before beginning assembly and installation of the
oven, check that all necessary components have
been received. In addition to the oven itself, legs,
the proper vent, and/or other accessories may be
required.
Single Sections
1060 with Steel Deck
D Legs, regulator, set of flue plates, draft diverter
and steel deck are shipped in the oven.
D Drafthood (when supplied) is packed separately.
1060 with Ultra Rokite Decks
D Legs, regulator, set of flue plates and draft diĆ
verter are shipped in oven.
D Ultra Rokite decks are packed in a separate carĆ
ton.
D Drafthood (when supplied) is packed separately.
Double Sections
1060 with Steel Deck
D Legs and bolts, regulator, set of flue plates and
steel deck are packed in the lower section.
D Regulator, set of flue plates, draft diverter and
steel deck are packed in the upper section.
D Crown angle leg frame is packed in a separate
carton.
D Drafthood (when supplied) is packed in a sepaĆ
rate carton.
1060 with Ultra Rokite Decks
D Legs and bolts, regulator, set of flue plates are
packed in the lower section.
D Regulator, draft diverter and a set of flue plates
are packed in the upper section.
D Ultra Rokite decks are packed in two separate
cartons.
D Crown angle leg frame is packed in a separate
carton.
D Drafthood (when supplied) is packed in a sepaĆ
rate carton.
LEG ATTACHMENT
1. Put the oven onto a genie lift with the bottom
of the oven down. Be careful not to damage
the louvered panel under the oven.
2. Each leg is attached by three bolts to the unĆ
derside of the oven base frame.
CASTER ATTACHMENT
1. Bolt supports to oven with 1/2Ć13 hex head
bolts (casters with brakes should be facing
front of oven.)
2. Carefully place oven onto the casters. (It will
be necessary to have several persons lift oven
off the pallet and set it onto the casters). EnĆ
gage brakes on front casters.
NOTE: A fixed restraint must be provided if castĆ
ers are used in conjunction with a flexible
connector for movable appliances. This
restraint must secure the oven to a nonĆ
movable surface to eliminate stress on the
connector. If the oven is moved, the reĆ
straint must be reconnected after the oven
is returned to it's normal position.
To Next Page
Loading...
