Blomberg BGR30420SS - Page 23

Code (CSA) and all local codes and ordinances. Refer
to the illustration below.
I CAUTION I
L N
•
G±
®
GOOD NO GOOD
120
VAC POLARITY SPECS A39074
Image is from blade side of plug
trical Gn:mnding Instruc-
tions
The appliance is equipped with a three-prong
(grounding) plug for your
protection against electrical shock hazard and
should be plugged directly
into a properly grounded three-prong recep-
tacle.
Do not cut or remove the grounding prong
from the plug.
r gas fired 120 VAC units and any NEG
compliant receptacle. proper ground ancl
correct
polarity Is required.
Electric convection ovens are configured at the
factory for operation from 208 VAG, single
phase, or 208 VAG, t11ree-phase electrical
service is also an available configuration.
Consult
wiring diagram located at tile end of til is
manual and on tile back side of lhe appliance.
ARN!NG
isk of electric shock. short circuit or fire by
1'-...l!.~namage of the main power supply'
The main power supply lead must not be
clamped, bent or trapped or come into contac;
with hot pmts of the appliance.
If the main power supply is damaged, it must
be replaced by a qualified electrician.
The gas cooker requires a 11 0/120VAC
11111111
.._..-electrical supply to operate the electronic
ignition system. The 6' (1.8 m) power supply
cord provided with the range is equipped with
a 3-prong, grounded plurJ for protection
against sl1ock hazard. Tile service s11ould
have its own 15 amp circuit bmaker.
'ou must follow all National Electrical Code
11111111 ...... .-and gas regulations.
In addition, be aware of local codes and
ordinances when Installing your services.
To prevent electrical shock, the grounding
•-•prong on the range cord should not be cut or
removed under any circumstances. it must be
plugged into a matching grounding type
receptacle and connected to a correctly
polarized 240-Volt dcuit. If there is any doubt
as to whether the wall 'eceptacle is properly
grounded, have it checked by a qual Jed
electrician.
RTANT:
,ot loosen the factmy installed nut con ..
ions wr1icl1 secure tim range wiring to
terminal block. Eiectrical failure or k1ss of
electical connection may occur if these 2
nuts are loosened or removed ..
• To align the appliance with the worktop,
adjust the feet turning rigtlt or left tland as
required.
23/EN