Blomberg BGR30420SS - Replacing the Oven Lamp

2
3. Move tt1e oven door to a slightly inclined
position.
4. Raise tile oven door forwards with your two
hands.
5. Once you complete cleaning, perform the
same procedure in reverse order to reinstall
the oven door.
m
Onee you complete cleaning, perform the
same procedure in reverse order to reinstall
he oven door.
efore replacing the oven lamp, make sure
1.._.:-~hat the product is disconnected from mains
and cooled down in order to avoid the risk of
an electrical shock.
Hot surfaces may cause burns!
rn
he oven lamp is a special electric light bulb
hat can resist up to 300"C (573 °F). See
Technical specifications. for details. Oven
lamps can be obtained from Authorised
Service Agents or technician with license.
mPosition of lamp might vary from the figure.
If your oven is equipped with a square lamp:
The oven lights can be illuminated with lamp
button. Tr1e ligr1ts are switched on when the door
is opened or when the oven is in a cooking cycle.
The oven lights are not illuminated during self
clean. Each light assembly consist of a remova-
ble lens, a ligllt bulb as well as a light socket
housing that is fixed in place. Light bulb re-
placement is considered to be a routine mainten-
ance item.
The oven lights are not illuminated during self
clean.
1. Turn off power at the main power supply
(your fuse or breaker box).
2. Remove the wire racks as described. See
Cleaning the oven.
3. Remove the protective glass cover with a
screwdriver.
4. Pull out oven lamp and replace it with new
one.
5. Install the glass cover and then the wire
racks.
45/EN