EasyManua.ls Logo

Blomberg KFD 9952 XA+ - Water Filter Installation

Blomberg KFD 9952 XA+
257 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
13
Installing Water Filter
(in some models)
Installation Requirements
Two different water sources may be
connected to the refrigerator for water
supply: the mains cold water supply and
water in a jug.
A pump should be used for jug water
usage.
Check that the parts stated below are
supplied with your appliance.
1. Union for connection of the water
pipe to the rear of the appliance
2. 3 pieces of pipe clips (In case
required to secure the water pipe)
C Note: Since the following parts are
not required in use with a jug, they
may not be found in the product you
purchased.
3. 5 meter long water pipe (1/4 inch in
diameter)
4. Cold mains water valve with mesh
filter (Tap Adapter)
5. Water Filter to be fitted to the bracket
inside the fridge compartment.
3
1
6
5
2
4

Table of Contents

Other manuals for Blomberg KFD 9952 XA+

Related product manuals