Blomberg LWF29441W - Draining Remaining Water and Cleaning the Pump Filter

36 / EN
Washing Machine /User’s Manual
4.7.5 Dranng remanng water and cleanng the pump flter
The filter system in your product prevents solid items such as buttons, coins and fabric
fibres clogging the pump impeller during discharge of washing water. Thus, the water will
be discharged without any problem and the service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be
cleaned whenever it is clogged or every 3 months. Water must be drained off first to clean
the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water
should be drained completely.
A
CAUTION: Foreign substances left in the pump filter may damage your product or may
cause noise problem.
CAUTION: In regions where freezing is possible, the supply tap must be closed, system
hose must be removed and the water inside the product must be drained when the product
is not in use.
CAUTION: After each use, turn off the water tap to which the mains hose is connected.
In order to clean the drty flter and dscharge the water:
1 Unplug the product to cut off the supply power.
A
CAUTION: 
the burning risk, clean the filter after the water inside the product is cooled down.
2. Open the filter cover.
3 Follow the below procedures in order to drain water.