SOS Leak Sensor Setup
In the Safety tab, select "Pixhawk Aux6" as the leak detector pin, and set the Logic when dry to "Low."
(https://bluerobotics.com/wp-content/uploads/2019/01/sos-software.png?x62571)
To The First Dive!
Your computer setup is now complete! Please see our Operation Manual to nish getting ready for your rst dive!
Power Sense Module (PSM) Installation
(https://bluerobotics.com/learn/power-sense-module-psm-installation/)
Learn how to install and setup a Power Sense Module on your BlueROV2 or other underwater project!
To Next Page
Loading...
