Blue Seal SG 4 E2 - Regeneration Cycle

22
Part 2: Reserved for Operator
ENGLISH
2.9 REGENERATION CYCLE
SG45EC2-SG5EC2-SD5EC2-SD5ECBT2
Resin regeneration is only possible with the door
CLOSED and the tank EMPTY
2.9.a FILLING THE SALT TANK
IMPORTANT
The tank is to be lled when alarm F4 appears on
the display.
First of all make sure that there is salt in the specic con-
tainer and proceed as follows:
1. Unscrew the cap of the salt tank and introduce salt tablets
suitable for water softening.
2. Screw the plug back on all the way to make sure the
tank is sealed.
2.9.c MANUAL REGENERATION OPERATIONS
(at the user’s discretion)
With the machine ON, perform the following operations:
2.9.b RESIN REGENERATION OPERATIONS
(AUTOMATIC) (only for mod. " A")
The resin is rinsed for a few seconds upon
every switch-on, and a MICROREGENERATION
cycle is then performed.
IMPORTANT
The MICROREGENERATION cycle takes place
in the background.
This could lengthen the cycle.
REGENERATION appears on the display
Touch the SCROLL key
Select the REGENERATION
function from the display
Touch the START key.
The REGENERATION phase
begins.
ATTENTION
Only an authorised technician can program the
regeneration parameters.
The machine is now ready for use.
ATTENTION
At this point the dishwasher carries out all the necessary
operations automatically for a preset time, during which
the machine cannot be used.
At the end of the cycle, the ma-
chine switches off automatically
and the display reads OFF.