Introduction
A. Overview
The Blue Fit50 is a hose clamp compatible with Blue Connect. It allows to install Blue Connect in the
technical room.
Note: Blue Fit50 is a Blue Connect accessory. It is available in the Blue Plus pack, or sold separately.
B. The box includes
One hose clamp.
One cap.
2 bolts.
C. Precautions for use
» Do not leave the Blue Connect on the Blue Fit50 when there is no water in the pipes.
» If handling on the hydraulic circuit (risk of water hammer), it is advisable to remove the Blue
Connect in order not to damage the product.
» Make sure to create a sufficient flow in your installation so that the Blue Connect can take
measures.
» Always place the Blue Connect vertically with the probe downwards.
Blue Fit50 installation
NB: Feel free to ask your pool specialist for advice in case of any doubt.
A. Find the correct location
Make sure to always place the Blue Fit50 after the lter (to avoid damaging the probes) and before
your product injection system or electrolysis (to avoid altering the measures taken by the
Blue Connect).
To Next Page
Loading...
