bluelab pH Pen User Manual

English
8
Bluelab Probe Care - pH
The instrument is only as accurate as
the probe is clean!
Bluelab pH Probe KCl Storage
Solution
The perfect solution to store and hydrate
your Bluelab pH products.
Probe cleaning is one of the most
important parts of owning and operating
any Bluelab meter, monitor or controller.
If the probe is contaminated (dirty) it affects
the accuracy of the reading displayed.
Bluelab pH Probe KCl Storage Solution is designed
to increase response time and maximize the life of
Bluelab pH pens and pH probes.
For best results, use the KCl solution to store the pH pen/
probe after use and hydrate monthly.
Instructions are on the label of the bottle.
› Bluelab pH Pen
› Bluelab Soil pH Pen
› Bluelab pH Probes
› Bluelab Soil pH Probes
Use Bluelab pH Probe KCl Storage Solution with:
10.0 Technical specications
Measurement range 0.0 - 14.0 pH
Resolution 0.1 pH
Accuracy (at 25°C / 77°F) ± 0.1 pH
Temperature compensation Automatic
Operating temperature 0 - 50 °C, 32 - 122 °F
Calibration Manual calibration, 2 or 3 points
Units pH, °F and °C
Power source 1 x AAA alkaline battery
› Probe care instructions
› 3 x plastic cups
› 20ml single-use Bluelab Solution
Sachets, 2 each of: pH 7.0 & pH 4.0, KCl
› Bluelab pH Probe Cleaner
› Toothbrush (pH probe cleaning
instrument)
Bluelab Probe Care Kit - pH contains:

bluelab pH Pen Specifications

General

Measurement Range	0.0 - 14.0 pH
Accuracy	+/- 0.1 pH
Resolution	0.1 pH
Automatic Temperature Compensation	Yes
Power Source	1 x AAA battery
Waterproof	Yes
Waterproof Rating	IP67
Calibration	Two-point calibration
Temperature Range	0 - 50 °C (32 - 122 °F)