BLUELIGHT BL6-U - Page 38

BL6-U Parallel Integrated Controller Quick Commissioning User Manual
37
Running Setup Parameters List (Cont'd)
Para
No.
Display
Content
Range
Factory
Setting
Unit
Live
Change
F1-13
S Curve P2
P2: Acceleration speed decrease
rate at end of elevator start; smaller
value means end of elevator start
with slow and steady movement.
0.1~1.0
0.5
m/s
3
N
F1-14
S Curve P3
P3: Deceleration speed increase
rate at beginning of elevator brake;
smaller value means beginning of
elevator brake with slow and steady
movement.
0.1~1.0
0.5
m/s
3
N
F1-15
S Curve P4
P4: Deceleration speed decrease
rate at end of elevator brake;
smaller value means end of elevator
brake with slow and steady
movement.
0.1~1.0
0.45
m/s
3
N
F1-16
Zero Speed
Motor speed less than set value,
system considers elevator speed as
zero and generates brake signal.
0~10
1
RPM
Y
F1-17
Leveling Adj
Adjust differences of up/ down
leveling
0~100
50
mm
N
F1-18
Load Adj
Normally used in synchronous
machine system, compensate
elevator load based on steel rope
weight difference on each floor.
0~20
0
--
Y
F1-21
Drive Mode
Selection of driving mode, when
setting “1”, attendant/VIP mode
close door manually; when setting
“3”, elevator automatically do test
run, other value is invalid.
0~9
0
--
N
F1-22
Two Door Mode
Setup rear door mode, based on
customer requirements, set from
mode”0” to”5”.
0~5
0
--
N
F1-23
Fire Mode
Three Fire modes:
1.Mode”0”: Elevator run fire-mode
after returning to fire floor;
2.Mode “1”: Elevator stop running
after returning to fire floor;
3. Mode “2”: After elevator return
to fire floor, depend on fire switch
to run/stop in fire mode.
0~2
0
--
N
F1-24
Parallel No.
Set “YES” in duplex enable. Set
elevator number 0-1 in duplex; 0-7
in group control.
0~7
0
--
N
F1-25
Twins Control
Elevator duplex control:
1: ON 0: OFF
0/1
0
--
Y
F1-26
Group Control
Elevator group control:
1: ON 0: OFF
0/1
0
--
Y
F1-27
Far Monitor
Remote Monitoring System:
1: ON 0: OFF
0/1
0
--
Y
F1-28
Auto Parking
Auto parking:
1: ON 0: OFF
0/1
0
--
Y
F1-29
Load Enable
Load Weighing:
1: ON 0: OFF
0/1
0
--
Y
F1-30
Open Delay Able
Door open/close delay:
1: ON 0: OFF
0/1
0
--
Y
F1-31
Brake Feedback
Test brake feedback signal:
1: open 2: close
0/1
0
--
Y
F1-32
Rerun Password
Password to release elevator stop.
0~9999
0
--
N