8
WARNING!
THIS IS A FACTORY RESET OF YOUR PLAYER. ALL CUSTOMIZATION INCLUDING WI-FI
NETWORK CONFIGURATION, FILE SHARES AND SAVED PLAYLISTS WILL BE LOST. YOU WILL
HAVE TO RE- CREATE THESE ONCE COMPLETE. THIS PROCESS IS ONLY RECOMMENDED IF
YOUR PLAYER IS NOT FUNCTIONING AND AN INTERNET FIRMWARE UPGRADE HAS FAILED.
FOR ANY QUESTIONS OR CONCERNS CONTACT AN AUTHORISED BLUESOUND CUSTOMER
REPRESENTATIVE BEFORE PROCEEDING!
Steps to Factory Reset:
1. Disconnect the NODE NANO from electrical power.
2. Wait 30 seconds.
3. Reconnect the power.
4. Once the LED turns Red, press and hold the PLAY/PAUSE button. The LED will immediately
turn Green and then back to Red - continue to hold the button for 30 seconds.
5. After 30 seconds, the LED will begin to blink red – then release the button.
6. All customization to the NODE NANO will be removed and restored to factory settings.
IMPORTANT Removing your finger from the PLAY/PAUSE button at any time before the LED begins
flashing red will cancel the factory reset and leave the NODE NANO in Upgrade Mode. Just start the
steps again to factory reset it.
You will know the factory reset is successful if the NODE NANO returns to Hotspot mode (wireless
connection - the LED will turn solid green). If it is connected to your network through a wired Ethernet
connection, it will simply connect as if it was a new player (LED will turn solid blue).
© Bluesound International. Bluesound, the stylized wordmark “B” logotype, the phrase
“HiFi for a wireless generation”, NODE NANO and all other Bluesound product names
and taglines are trademarks or registered trademarks of Bluesound International, a
division of Lenbrook Industries Limited. All other logos and services are trademarks or
service marks of their respective owners.
To Previous Page
Loading...
