_ Power Cord Protection - Power-supply cords should
be
routed
so
that they are not likely
to
be
walked
on
or pinched by items placed upon or against them, paying particular attention
to
cords at plugs,
convenience receptacles, and the point where they exit from the product.
_Outdoor
Antenna Grounding - If
an
outside antenna or cable system
is
connected
to
the product,
be
sure the antenna or cable system
is
grounded
so
as
to
provide some protection against voltage surges
and built-up static charges. Article 810 of the National Electrical
Code,
ANSI/NFPA 70, provides
information with regard
to
proper grounding of the mast and supporting structure, grounding of the lead-
in wire
to
an
antenna discharge unit, size of grounding conductors, location of antenna discharge unit,
connection
to
grounding electrodes, and requirements for the grounding electrode.
_ Lightning - For added protection for this product during a lightning storm, or when it
is
left unattended
and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna
or
cable
system. This
will
prevent damage
to
the product due
to
lightning and power line surges.
_ Power Lines - An outside antenna system should not
be
located in the vicinity of overhead power
lines or other electric light or power circuits, or where it can fall into such power lines
or
circuits. When
installing
an
outside antenna system, extreme care should
be
taken
to
keep from touching such power
lines or circuits
as
contact with them might
be
fatal.
_ Overloading -
Do
not overload
wall
outlets, extension cords, or integral convenience receptacles
as
this
can result in a risk of fire or electric shock.
_ Object and Liquid Entry - Never push objects of any kind into this product through openings
as
they
may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never
spill liquid of any kind
on
the product.
Warning
The apparatus should not
be
exposed to dripping or splashing, and objects filled
with
liquids, such
as
vases, should not
be
placed
on
the apparatus. As
with
any electronic products, use care not to
spill
liquids into any part of the system. Liquids can cause a failure
and/or
a fire hazard.
_ Damage Requiring Service - Unplug this product from the wall outlet and refer servicing
to
qualified
service personnel under the following conditions:
_When
the power supply cord or plug is damaged.
_ If liquid has been spilled, or objects have fallen into the product.
_ If the product has been exposed
to
rain or water
..
_ If the product does not operate normally by following the operating instructions.
Adjust only those controls that
are
covered by the operating instructions
as
an
improper adjustment of other controls may result in damage and
will
often require
extensive work by a qualified technician
to
restore the product
to
its normal operation.
_ If the product has been dropped or damaged in any way.
_When
the product exhibits a distinct change in performance-this indicates a need for service.
_ Replacement Parts - When replacement parts are required,
be
sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics
as
the original part.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
_Safety
Check - Upon completion of any service or repairs
to
this product, ask the service technician
to
perform safety checks
to
determine that the product is in proper operating condition.
7
To Next Page
Loading...
