_ Heat - The product should
be
situated away from heat sources such
as
radiators, heat registers, stoves
or other products (including amplifiers) that produce heat.
Battery shall not
be
exposed to excessive heat such
as
sunshine, fire or the like.
Warning
To
reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
Caution
To
prevent electric shock, match wide blade of plug to wide slot,
fully
insert.
Warning
Main plug is used to disconnect device and
it
should remain readily operable during intended use.
Caution
Danger of explosion
if
battery*
is
incorrectly
replaced. Replace
only
with
the same or equivalent type.
* Applies
only
to BP100 for PULSE FLEX.
RESPONSIBLE
PARTY
Lenbrook Industries Limited,
633
Granite Court, Pickering, Ontario
L1W
3K1
Warning
Changes or modifications to this
unit
not expressly approved by the
party
responsible for compliance
could void the user's authority to operate the equipment.
Note
This equipment has been tested and found
to
comply with the limits for a Class B digital device, pursuant
to
Part
15
of the
FCC
Rules. These limits are designed
to
provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to
radio communications. However, there is
no
guarantee that interference
will
not occur in a particular
installation. If this equipment does cause harmful interference
to
radio or television reception, which
can
be
determined by turning the equipment off and on, the user
is
encouraged
to
try
to
correct the
interference by one or more of the following measures:
_ Reorient or relocate the receiving antenna.
_ Increase the separation between the equipment and receiver.
_ Connect the equipment into
an
outlet
on
a circuit different from that
to
which the receiver
is
connected.
_ Consult the dealer or
an
experienced radio/ TV technician for help.
8