Bluetti AC200P - Appendix; FAQs (Frequently Asked Questions)

JUST POWER ON 14
Appendix
FAQs (Frequently Asked Questions)
Q: How do I know whether my devices will work well with this product?
A: Please evaluate the total constant load of your appliances. If it doesn't exceed
the Max. output power of AC200P, you can use this power station.
Q: Can I use third-party solar panels to charge this product?
A: Yes, you can. Make sure your solar panels have an open circuit voltage of
35V-150V and have the MC4 connectors. Please do NOT mix different types of
solar panels.
Q: What does the Depth of Discharge(DoD) refer to?
A: DoD indicates the fraction of power that can be withdrawn from the battery.
The BLUETTI AC200P sets the DoD to 90%, which means that 90% of the
capacity is available to power your device, while the reserved is used to
protect the battery from over-discharging.
Q: Can it charge and discharge at the same time?
A: Yes, but it has no UPS feature.
Q: How to disable the touch screen sound?
A: Sorry, it cannot be turned off.
Q: How to put the screen to sleep while charging and discharging?
A: The screen has no sleep mode and stays on whenever AC200P charges or
discharges.
Q: Can it run my refrigerator, window air conditioner or power drill?
A: Yes, but they typically require a startup power of 5-7 times the rated, easily
overloading AC200P.
Q: Can two AC200P be paired for higher output voltage, power and capacity?
A: No.
Q: Can the AC200P be connected to the home circuit breaker box?
A: No.
Q: Why does the screen display 0 watt output when I plug in a small load,
like a 35W LED lamp?
A: The current is too small to be measured accurately when connected to low loads.