Note: DoD refers to the Depth of Discharge, η is the local inverter efficiency. DoD=90%, η=90%.
DoD may vary depending on ambient-operating temperature and discharge rate.
Load power and charging time are measured in Watt and Hour.
* The lead-acid charging cable is for recharging AC200P ONLY.
Please contact BLUETTI customer service for details and get it directly from
https://www.bluettipower.com/products/12v-24v-lead-acid-battery-charging-cable.
Discharging
2000Wh* × DoD × η ÷ (load power) = charging time (estimated)
JUST POWER ON13
Note: Set the ‘Car’ as DC input source to enable lead-acid battery charging.
If charging AC200P with a 12V lead-acid battery, make sure it discharges at
above 11.5V. If it’s a 24V lead-acid battery, the discharge voltage should be
higher than 23V.
The Max. input current is 8.2A.
12V/24V Lead-acid Battery Charging
Connect AC200P to the battery via multifunctional DC charging cable and
lead-acid battery charging cable*. Clamp the positive connector (red) to the
positive battery terminal and negative (black) to the other.
Slow Cooker
8-9hrs
200W
TV
20-22hrs
75W
LED Light
75-85hrs
20W
Power Tools
19-20hrs
80W
Fridge
17-19hrs
90W
Cellphone
150-160 Times
10Wh
To Next Page
Loading...
