8.3 Frequency Switching
The current output frequency (50Hz / 60Hz) is displayed in the lower right corner of the
screen. In the Setting Mode, press the AC power button to switch the frequency options
based on your requirements.
8.2 ECO Mode
ECO Mode is a power-saving mode that is enabled by default. When operating on ECO
Mode, the AC / DC output will automatically turn off if the AC70 is bearing low (less than
40W or the set power) or no load for a while.
Note: When connecting a small power device, disable the ECO Mode for a successful
and uninterrupted charge experience.
In the Setting Mode, press the DC power button to enable or disable the ECO Mode.
You'll see the icon displayed on the screen when it's enabled.
8.5 AC Charging Mode
The AC70 supports 3 AC charging modes - Standard, Turbo, and Silent to fit your specific
needs. In the Setting Mode, press the button to switch the options. Please refer to the
below table for useful instructions.
8.4 Power Lifting Mode
Power Lifting Mode allows AC70 to handle high-power resistive loads up to 2000W,
which is disabled by default. In the Setting Mode, press and hold the AC power button to
enable or disable it. You'll see the icon displays on the screen when it's enabled.
This mode is particularly useful when using the AC70 with demanding heating devices
such as kettles, electric blankets, and hairdryers. If the screen reads "OVERLOAD" while
operating such devices, activating Power Lifting mode allows the AC70 to tackle these
tasks effectively.
Note: The resistive loads should have a power rating between 1000W and 2000W.
Although the AC70 can handle higher power demands, its actual operating power
remains at 1000W.
AC Charging Mode Instructions
Mode
Standard
Turbo
2 hours
Recharging Time
80% charge in 45 minutes;
full charge in 1.5 hours
Note
Silent
4 hours
More friendly to AC70's battery.
Comes in handy when recharging
time is a priority.
Offers a quiet, low-power operation
for long battery life.
JUST POWER ON 17
To Next Page
Loading...
