What to do if Bluetti EB240 has under-temperature protection when charging the battery?
If your Bluetti Portable Generator shows under-temperature protection when charging the battery, wait for a while for it to heat up and then restart the machine.
What to do if my Bluetti EB240 Portable Generator shows over-load protection of inverter?
To resolve an over-load protection of the inverter on your Bluetti Portable Generator, verify if the output port is overloaded. Then, turn off and on the AC output to restore normal operation.
How to fix battery protection on Bluetti Portable Generator?
If your Bluetti Portable Generator is experiencing battery protection, disconnect the solar charging cable and restart the machine.
What to do for battery failure on Bluetti Portable Generator?
If your Bluetti Portable Generator indicates a battery failure, restart the machine and charge it.
What to do if the temperature of the heat sink is not detected in Bluetti Portable Generator?
If the temperature of the heat sink is not detected in your Bluetti Portable Generator, insert the NTC and restart the machine.
What to do if Bluetti Portable Generator shows under-temperature protection when charging the battery?
If your Bluetti Portable Generator shows under-temperature protection when charging the battery, wait for a while for it to heat up and then restart the machine.
How to fix under-voltage protection for the 1st cell on Bluetti EB240 Portable Generator?
If your Bluetti Portable Generator displays an under-voltage protection error for the 1st cell, charge the product promptly and restart it once fully charged.
How to resolve under-voltage protection for the 2nd cell on Bluetti EB240?
If your Bluetti Portable Generator displays an under-voltage protection error for the 2nd cell, charge the product promptly and restart it once fully charged.
How to fix busbar fault of inverter due to under-voltage on Bluetti EB240 Portable Generator?
If your Bluetti Portable Generator experiences a busbar fault of inverter due to under-voltage, turn the machine off and on.
How to fix over-voltage protection (PV input) on Bluetti EB240?
If your Bluetti Portable Generator displays an over-voltage protection error related to the PV input, disconnect the solar charging cable and then restart the machine.
Explains the meaning of charging power, DC/AC ON/OFF status, and battery status indicator on the screen.
Provides essential warnings regarding reading the manual, using warning labels, avoiding water, heat sources, and unauthorized modifications.
Provides key operational advice on environment requirements, air inlet/outlet, powering off when idle, and full charging for long periods.
Provides a table of error codes (E001-E004) and their corresponding problems and solutions, covering protections and failures.
Lists additional error codes (E005-E019) and their solutions, focusing on temperature, voltage, and inverter faults.
Details further error codes (E020-E023) and solutions related to temperature detection, charging, and power protection.
Details specifications for continuous output voltage, rated frequency, power, power factor, THDV, overload protection, and efficiency.
Details battery specifications like voltage, capacity, cell type, packing, IP rating, operating environment, dimensions, and net weight.
General| Battery Capacity | 2400Wh |
|---|---|
| Battery Type | LiFePO4 |
| Rated Power | 1000W |
| Surge Power | 1200W |
| Cycle Life | 2500+ cycles to 80% capacity |
| AC Output Voltage | 110V |
| AC Output Frequency | 60Hz |
| Car Port Output | 12V/9A |
| USB Output | 4 x USB-A (5V/3A) |
| DC Output | 12V/9A |
| Weight | 22 kg (48.5 lbs) |
| Solar Input | 16-60V/ 10A, Max.500W |
| Dimensions | 19.4 x 6.5 x 14.4 inches |
To Next Page
