What to do if Bluetti EP900 Storage shows EEPROM read and write anomaly?
If the Bluetti storage shows an EEPROM read and write anomaly, reconfigure the settings on the BLUETTI app. If the problem persists, contact the BLUETTI support team.
What to do if Bluetti EP900 Storage shows 'Grid Voltage High'?
If the Bluetti storage system shows a 'Grid Voltage High' error occasionally, it might be due to abnormal grid conditions; the inverter should recover once the grid stabilizes. However, frequent occurrences suggest checking if your grid voltage and frequency match the inverter's specifications, inspecting the inverter's AC circuit breaker and connections. If voltage and frequency are consistently out of range, further assistance from BLUETTI support is needed.
What to do if Bluetti EP900 Storage shows BUS Overvoltage?
If your Bluetti storage displays a 'BUS Overvoltage' error, turn off the inverter and wait 30 minutes before restarting it. If the problem continues, please contact the BLUETTI support team.
How to fix Bluetti EP900 Storage USB format error?
The USB should be formatted as FAT32 with no more than 32G in size. Check if the upgrade files exist or expire. Please download the latest upgrade files.
What to do if Bluetti EP900 shows PV1 Overcurrent?
If your Bluetti storage is showing a 'PV1 Overcurrent' error, turn off the inverter, wait 30 minutes, and then restart it. If the problem continues after restarting, please contact the BLUETTI support team.
What to do if Bluetti EP900 reports a fan failure?
If the Bluetti storage reports a fan failure, check if the inverter fan is operating correctly.
What to do if Bluetti EP900 meter communication fails?
If you're experiencing a meter communication failure with your Bluetti EP900 energy storage system, check that the meter is powered on and that the communication cable between the meter and the EP900 is properly connected. If the problem continues, please contact technical support.
What to do if Bluetti EP900 Storage shows PV1 Voltage High?
If you're seeing a 'PV1 Voltage High' error on your Bluetti storage, it means the total voltage from your solar panels is too high. You should reduce the number of solar panels connected. After doing so, the inverter will resume operation after calibration.
What to do if Bluetti EP900 USB upgrade fails?
If the Bluetti storage USB upgrade fails, turn the inverter on again. If the issue persists, contact the BLUETTI support team.
What to do if Bluetti EP900 has a communication failure?
If your Bluetti storage experiences a communication failure, turn off the inverter, wait 30 minutes, and then restart it. If the issue persists, please contact the BLUETTI support team for further assistance.
Details crucial safety guidelines for operating, installing, and maintaining the EP900 system.
Outlines essential general safety precautions to ensure safe operation of the EP900 energy storage system.
Provides critical safety instructions specifically for the EP900's battery pack, covering handling and operation.
Covers personal safety measures and required protective equipment for users during system operation.
Specifies the necessary requirements and precautions for safely installing the EP900 battery pack.
Details immediate safety actions and precautions to be taken in the event of a fire involving the system.
Provides emergency procedures and safety advice if the battery pack is dropped or severely impacted.
Provides step-by-step instructions for safely powering on the EP900 energy storage system.
Provides step-by-step instructions for safely powering off the EP900 energy storage system.
General| Nominal Voltage | 51.2V |
|---|---|
| Output Voltage | 120V/240V |
| Warranty | 10 Years |
| Battery Type | LiFePO4 |
| Inverter Power | 9, 000W |
| Solar Input | 150-500V |
| Cycle Life | 3, 500+ Cycles to 80% Original Capacity |
To Next Page
