NPA70DA USER MANUAL
Contact: support@blustream.com.au | support@blustream-us.com | support@blustream.co.uk 03
Our NPA70DA networked audio zone amplifier delivers advanced audio
integration within a commercial or residential AV installation.
The NPA70DA features a 2 x 35W digital amplifier (1 x 70W mono) or 70V / 100V
hi-level constant voltage output and Dante® audio integration.
The NPA70DA can be powered via PoE++ from a compatible network switch, or
locally should the switch not support PoE++. The unit also includes the ability
to lower the amplifier power output subject to PoE capabilities, support for
combined or independent LAN and Dante® connections, DSP with a 31 band
EQ, audio delay for lip sync correction, and control via front panel, IR, RS-232,
TCP/IP, web-GUI or 12V trigger.
Introduction
FEATURES:
• Advanced network audio amplifier with Dante® integration
• Supports 2 x 35W @ 4 / 8 ohm, 1 x 70W @ 4 / 8 ohm or 70 / 100V constant output for multiple speakers with longer
cable runs
• Supports power via PoE++ on Dante® LAN connection or local power supply*
• Dual network option - independent Dante® and LAN control ports, or combined to a single LAN
• 2ch Dante® / AES67 audio input
• DSP with 31 band EQ with +3dB/-10dB and audio delay
• Local 12V input trigger for automated power control
• Control via front panel, IR, RS-232 and IP
• Auto standby mode with signal sensing
• In-built web-GUI for setup and control
* Amp power limited when using PoE+
To Next Page
Loading...