BluStream NPA70DA - Front Panel Description; Rear Panel Description

NPA70DA USER MANUAL
www.blustream.com.au | www.blustream-us.com | www.blustream.co.uk04
Front Panel Description
1 Power Status LED
2 ID LED - Illuminates to assist in identification of the device
3 Volume Level LED’s - Illuminates to show current volume level
4 Volume Mute Button - Toggles audio mute on or o
5 Volume - Button - Decrease master output volume
6 Volume + Button - Increase master output volume
1 Network Mode Switch - Mode 1 allows Dante® audio and TCP/IP and web-GUI control via the Dante® PoE port
- Mode 2 allows Dante® audio via the Dante® PoE Port, and TCP/IP and web-GUI control via the TCP/IP port
2 Dante® (PoE++) Port - RJ45 connector supporting PoE++ to power NPA70DA from the network switch
3 TCP/IP Port - RJ45 connector for TCP/IP and web-GUI control of the device (When Network mode is set to 2)
4 RS-232 - Phoenix connector for RS-232 control of the device
5 Trigger Input - Phoenix connector triggers device power on/o. Low level (0V) to turn amp on, high level (5-12V) to turn amp o
6 IR Input - 3-pin Phoenix connector to connect to Blustream IR receiver for IR control of the device
7 IR Voltage Switch - Select between 5V or 12V IR voltage. Please note: included Blustream IR accessories are 5V
8 Speaker Output - Phoenix connector to connect speaker outputs, see Speaker Connections section for more information
9 Speaker Impedance Switch - Select low impedance (LO-Z, 4-8 ohm) speakers, or high impedance (HI-70V or HI-100V) speakers
q Power Port - Use included 24V/3.5A DC power adaptor if not powered via PoE++ device
Rear Panel Description
1 4 5 632
NPA70DA
VOLUME
Dante Networked Power Amplier
DANTE(PoE)
TCP/IP
CONTROL
TX
RX
RS-232
T
TRG
S
V
IR IN IR
5V 12V
R+ R- L+ L- 100V 70V COM
+
BRIDGED
-
SPEAKER OUTPUT
4Ω
8Ω
70V
100V
MODE 1 MODE 2
NETWORK
24V 3.5A
1 4 5 632 7 8 9 10