NPA70DA USER MANUAL
www.blustream.com.au | www.blustream-us.com | www.blustream.co.uk08
Advanced Dante® Settings
It is possible to change various Dante® related settings of the NPA70DA under the “Device Info” screen in the Dante®
Controller soware. To do so, select the “Device Config” menu.
Here it is possible to adjust the sample rate of the NPA70DA. Please note: that Dante® products can only transmit
or receive audio from other Dante® products that are set up with the same sample rate. A mismatch in sample rate
may stop audio from transmitting.
Under the “Device Config” screen the latency of the NPA70DA can be configured with 1, 2 or 5 milliseconds delay.
By default, the NPA70DA is shipped with the network settings set to obtain an IP Address automatically. This means
that if a DHCP server is present on the network, the NPA70DA will be provided with an IP Address. If no DHCP server
is present then the NPA70DA will receive a default IP Address in the 169.254.xxx.xxx range. To change the IP Address
of the NPA70DA, enter the “Network Config” menu in the “Device Info” screen of the Dante® Controller soware:
Dante® Controller
To Next Page
Loading...