NPA70DA USER MANUAL
Contact: support@blustream.com.au | support@blustream-us.com | support@blustream.co.uk 15
Telnet & RS-232 Control Port
Baud Rate: 57600 bps
Data Bit: 8-bit
Parity: None
Stop Bit: 1-bit
Flow Control: None
The NPA70DA can be controlled via a 3-pin Phoenix to serial RS-232 cable or via Telnet.
The RS-232 communication settings and commands are as follows:
RS-232 / TELNET COMMAND DESCRIPTION
?/HELP Print Help Information
STATUS
Print System Status And Port Status
PON Power On, System Run On Normal State
POFF Power O, System Run On Power Save State
PWLED FOLLOW ON/OFF ON: Set System Power Led Follow LCD Status
OFF: Set System Power Led Not Follow LCD Status In Power On State,Power Led Always On
RESET "Reset System Settings To Default
(Should Type ""Yes"" To Confirm, ""No"" To Discard)"
RESET ALL "Reset System and Network Settings To Default
(Should Type ""Yes"" To Confirm, ""No"" To Discard)"
REBOOT Set System Reboot
AUTO STB xx Set System Auto Standby Time
xx=0:Auto Standby O
xx=[1...120]:Auto Standby Time,(mins)
AMPMODE xxx
Set Amp Power to xxx
xxx=2:PoE++ Type 4 Class 8 (71W)
xxx=3:PoE++ Type 4 Class 7 (62W)
xxx=4:PoE++ Type 3 Class 6 (51W)
xxx=5:PoE++ Type 3 Class 5 (40W)
xxx=6:PoE+ Type 2 Class 4 (25.5W)
KEY ON/OFF
Set System KEY Control On Or O
LCD ON/OFF/15/30/60
Set LCD Always On Or Auto Turn O In Power On State Or Turn On 15s/30s/60s
IDLED ON/OFF/15/30/60
Set IDLED On Or Auto Turn O In 15/30/60s In Power On State Or Turn On 15s/30s/60s
IR ON/OFF
Set System IR Control On Or O
TRIG ON/OFF
Set Trigger On Or O
RSB xx Set RS232 Baud Rate to xx bps
xx=[1...6]:1:4800,2:9600,3:19200, 4:38400,5:57600,6:115200
IN VOL yy Set Input Volume to yy
yy=[0...100]:Volume Value
IN VOL+ Increase Input Volume
IN VOL- Decrease Input Volume
IN xx MUTE ON/OFF Set Input Mute On Or O
OUT VOL yy Set Output Volume to yy
yy=[0...100]:Volume Value
OU T VOL+ Increase Output Volume
OUT VOL- Decrease Output Volume
OUT MUTE ON/OFF Set Output Mute On Or O
To Next Page
Loading...